Description
| Europe’s third-generation interior wall paint with very high abrasion and moisture resistance comparable to that of wall tiles when used with a water-proof primer. A semi-matt, super low-odour, mould resistant waterborne acrylate latex finishing paint for use on interior walls and ceilings. It is especially good for use in humid rooms and areas, e.g. kitchens, bathrooms and washing rooms, although equally applicable to living rooms and bedrooms. It conforms to the Finnish M1 emission classification and has strong scrub resistance (10,000 times to and fro). | |
| Note: The price(s) shown above is (are) for white paints only. A tinting fee is charged for paints of other colours. | |
| Country of Origin: | Finland |
| Thinner: | Water |
| Base paints: | ‘A’ and ‘C’ paints. ‘A’ paint is white in colour and can be applied directly or upon being tinted, ‘C’ paint cannot be applied directly and must be tinted before use. |
| Chemical resistance: | Withstands solvents. |
| Colour Range: | Available in white and the complete Tikkurila Symphony Colour Collection. |
| Application Details: | All surfaces to be painted must be dry, the temperature of the air at least +5°C and the relative humidity of the air below 80%. |
| Application method: | Brush, roller or spray application. |
| Thinning: | Thin with up to 10% of water if necessary. |
| Coverage: |
7-9㎡ x 2 coats / Litre This information is only intended as a guide. The actual coverage will depend on the substrate texture, absorption rate, application methods, and many other factors. |
| Preparation: |
The surface to be painted must be clean, dry and free of grease, dust and fibres. Wash down previously painted surfaces with a cleaning agent, rinse carefully and let dry. Remove loose, flaking paint with a scraper. Treat moulded walls with a suitable mould removing solvent and then rinse with water. Sand hard or glossy surfaces to a matt finish and remove sanding dust. Fill holes and cracks with a suitable filler and sand the dried surface. Prime the surface with Feelings Universal Primer before coating, if necessary. In the case of a wet area, e.g. bathroom, use a waterproof filler to fill holes and cracks and prime the walls and ceiling with Feelings Moisture Stop. For unpainted surfaces: remove all dirt and dust. If necessary, fill holes and cracks with a suitable filler and sand the dried surface. Remove sanding dust. Prime with e.g. Feelings Universal Primer. |
| Painting: | Stir Feelings Extra Durable well before use and thin with up to 10% of water, if necessary. Apply two finishing coats by brush, roller or spray. Painting should be done on a dry wall at a ROOM temperature above 5℃ and a relative humidity below 80%. Normally touch-dry in 2 hours and recoatable after 4 hours. |
| Environmental and waste disposal | Empty tins should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations. |
| Storage | Protect from frost. Any remaining paint can be preserved for future use with the cap placed back on. |
| Shelf Life | 3 years with the cap still intact. The expiry date is marked on the tin. |
| The above information is not intended to be exhaustive or complete. The information is based on laboratory tests and practical experience, and it is given to the best of our knowledge. The quality of the product is ensured by Tikkurila’s operational system, based on the requirements of ISO 9001 and ISO 14001. As manufacturer Tikkurila cannot control the conditions under which the product is being used or the many factors that have an effect on the use and application of the product. Tikkurila disclaims liability for any damages caused by using the product against our instructions or for inappropriate purposes. Tikkurila reserves the right to change the given information unilaterally without notice. | |
